EPDM Rubber Roofing
in Killington, VT

EPDM rubber roof installation in Killington, VT starts with what winter damaged. Soaked insulation and soft decking come out, because covering wet board guarantees an early failure.

New insulation and one membrane sheet go down. Seams, corners, and terminations on a Killington roof get sealed into a single continuous surface.

Snow sits here for months. A Killington flat roof carries that load all winter, so the framing and deck get checked before any membrane work.

EPDM roof repair in Killington often follows snow dropping from the roof above. The impact tears membrane on entries, decks, and connector roofs below.

Ice does the slower damage. Meltwater on a Killington flat section finds an open seam, freezes overnight, and widens the opening every thaw cycle.

We patch, reseal, and replace wet insulation, then explain what caused it, because the same Killington conditions return every winter without fail.

Flat roof maintenance in Killington, VT happens before the season. Drains cleared, seams checked, terminations inspected, and storm damage caught while the roof is bare.

Rental owners rely on the report. A Killington flat roof under snow gets no attention until a guest reports water coming through.

Photos and a written list follow every single visit, so the Killington owner sees the membrane condition without making the drive up.