EPDM Rubber Roofing
in Montpelier, VT

EPDM rubber roof installation in Montpelier, VT begins by opening the old roof. Wet insulation and rotted decking come out, because snow melt has usually been getting in for years.

Insulation board goes down, then the membrane over it in one sheet. Seams and wall terminations on a Montpelier roof get sealed as a continuous surface.

Snow load matters even on flat sections. A Montpelier rubber roof holds weight all winter, so the deck has to be sound before the membrane is set.

EPDM roof repair in Montpelier usually follows a thaw. Ice sits on the membrane, meltwater finds an open seam, and the stain shows up on the ceiling below.

Shrinkage is the other failure. Older Montpelier membranes pull tight at the walls and corners, and the terminations open where the rubber loses its grip.

We patch the membrane, reseal the terminations, and check the insulation below. Wet board under a Montpelier roof never dries out on its own.

Flat roof maintenance in Montpelier, VT is a fall job. Drains cleared, seams checked, terminations inspected, and debris removed before snow covers everything for months.

Snow load gets discussed too. Deep accumulation on a Montpelier flat roof adds real weight, and we tell you what is reasonable to leave alone.

After each visit you get photos and a plain written list of what the Montpelier rubber roof needs and what can wait.