EPDM Rubber Roofing
in St. Albans, VT

EPDM rubber roof installation in St. Albans, VT starts with tearing off what failed. Wet insulation and soft decking come out before any new membrane is considered.

Insulation board and a single rubber sheet follow. Seams, corners, and terminations on a St. Albans roof are sealed into one continuous drainage surface.

Open country wind shapes the edge detail. On St. Albans properties the terminations get fastened so gusts cannot work their way under the membrane.

EPDM roof repair in St. Albans usually starts at a seam, a boot, or a wall termination that dried out and opened over the years.

Wind damage shows up at the edges. A lifted termination on a St. Albans flat roof lets water travel under the membrane far from the visible damage.

We patch, reseal, and check the insulation underneath, then say plainly whether the St. Albans membrane is worth keeping or is finished.

Flat roof maintenance in St. Albans, VT covers drains, seams, terminations, and debris. Shop and barn roofs get the same annual attention as the house.

Standing water is the main issue. A St. Albans flat roof that never drains holds weight and breaks the membrane down from above.

Every visit ends with photos and a written list, so the St. Albans owner can budget work instead of reacting to leaks.